[This site - shoes and life] buy a new pointe shoes also need to go through their own "processing" - sewn ribbons. In the position of the arch, a ribbon is sewn on the left and right sides. Prepare a wide rubber band yourself and sewn together on the heel. This rubber band is not a necessary accessory, but it helps to better fix the shoe on the foot. Some people have a particularly high instep. On ONPOINTE, often the heel slips. With this rubber band, this problem is solved.
When you are ready to work, you should wear shoes. First, put the toe sleeve on the toe, if there is a rubber band, first through the rubber band, wear shoes, feet flat on the ground. Adjust the position of the rubber band to the ankle. Then tie the ribbon again. The longer the ribbon is, the better, and the more loops the better. First, put the ribbon on one side of the arch over the instep and wrap it around the ankle. Wrap around the ankle in the thinnest place and fix it on the inside. Then, wrap the ribbon on the outside of the foot in the opposite direction. Note that the ribbon must be completely flattened and wrapped around the feet so that a very nice cross crosses the two ribbons on the instep. Finally, put two ribbons on the inner side of the ankle to make a bow. The knot doesn't need to be big, and the little one is fine. After subtracting the extra ribbon, carefully put the knot into the ribbon next to it. No knot should be seen from any direction. Therefore, the knot should not be played too much. If it is too big, it will puff up and affect the beauty of the entire leg line. (Cooperative Media: Garment Collocation)
V-Neck Top,Round Top,Cropped Top,Ruched Top
Shaoxing Julong Trading Co.,Ltd. , https://www.julong-foeec.com